Damascus Steel Weekend Workshop
11 Waiu St, Lower Hutt, Wellington RegionTicket Information
- Additional fees may apply
Restrictions
Website
Listed by
In this is a two day course you will be taken through the full process of fusing and folding your stack of metal, to creating and patterning a 100 layered billet.
After an introduction to metallurgy and the theory of pattern making, you will begin forge welding a 20 layered billet of 1070 and 15N20 steel using the power hammer. Once fused into a single block and drawn out it will be cut into 5 pieces, re-stacked, welded and then drawn out again to produce 100 layers.
The billet will then be surface textured to create your chosen pattern and then ground down to a thin plate. At this point etching your billet in acid will reveal the pattern.
There is a limit of only four places per course.
Please note: This is not a Knifemaking Class. Following this workshop, students may choose book into a knife making workshop, a blacksmithing workshop or receive private tutoring for a specific project.
Log in / Sign up
Continuing confirms your acceptance of our terms of service.
Post a comment